i Have a pcb layout in PDF both layers and solder mask and also in protel 2.7 .pcb file and solder mask and BOM in excel. I would like the pcb layout to be done in Proteus 8 and also work out schematic which is not existing.
The design must be ready for simulation after completion i will not give the hex file for the microcontroller
I have experience with reverce engeneering, working with incomplete pcb documentation set, corrections etc. Can I see the BOM to estimate volume of work?
i have read and understood your requirements..
Please open chat to discuss further....
1===============================================================
If you are looking for PCB Layout designer you can hire me. I do processor level design. I generally used Altium But you want it in Proteus Ok fine I can do it. Proteus was my first hand tool in PCB design.
Share your requirement and Share with me i will assist you better. Thanks
Hello, I'm Ayfer, From Turkey.
I have 15 years pcb to draw experience and in addition have 10 years pcb production experience.
I can to draw scrupulously your pcb and create its' documents.
I will lots of work experience and accurate work for all layer of PCB and bill of material and component with exact footpriend design circuit PCB layout...show my profile for more or conatct
hello, I've seen your attached jpg file but it's seem to be too small to clear the part and the connection in the board. Give me the protel pcb file and I'll redraw it into Proteus file for you - it's nice to see you soon
Hi sir
I have just finished a project that design PCB for American Engineer about BLE
I have more than 3 years experience in Design PCB using Altium/Orcad/Eagle
and has experience in Proteus Simulation (ISIS) and Layout (ARES)
I hope to work with you this Project
Please see my profile to get more information about me and my skill
Thanks a lot
Manh.