Hello I'm an Amazon Seller, and run a Mexican Restaurant in Valdosta Ga. I need help designing a product for a supplier on Alibaba. I sent them a picture of a product i was interested in and they asked me for a 3D model with all the measurements. I need help with a 3D model of the image down below. Its a flight for shots/margarita/beer. Its a sandal with 5 shot holders. I have all the measurements. I just need help designing a 3D model with the measurements on the side.

Looking for a creative experienced Product Designer who can design Android App screens for our FinTech application on Figma. We would share the Balsamiq Wireframes with you for reference. More Details about the project and the wireframes to be shared with the right person. Would prefer to work with an Individual Freelancer instead of Agencies.

A proposal is required for testing a moisture recording device being developed for reading the surface moisture level present in a piece of cardboard. An experiment is to be designed by the successful applicant for developing a method to test low-level moisture content present in cardboard. The device must be able to operate in an RH% range from 50 – 95%, & read moisture content 5-16%, most important at the higher end of that moisture content range. The project requires the development of an experiment to test moisture content in cardboard. type of device which is able to read the surface moisture content of cardboard without damaging the surface (the device must not penetrate the cardboard). Any type of device may be used and this project is only for the proposal of the design of an experiment to test the surface moisture content present on a piece of cardboard. As the successful applicant, you will be required to develop an experiment to test the moisture content on several pieces of cardboard including a method for performing the testing. If your method is successful then a later project will be available for the development of the device for commercial use.

I am looking for an engineer to design a floating cage to swim long distances in the sea, while protected fron sea predators and large jellyfish. The cage is inspired in the one from the following link https://www.swimmingworldmagazine.com/news/marathon-swimming-in-a-shark-cage-a-unique-way-to-race-in-the-open-water/ Considerations: - can be built on pneumatic boats like the one in the picture as the base. Ideally we can design it based on existing second hand pneumatic boats - length should be of 7 meters long and 3 mtrs. Wide to allow for 2 pairs of swimmers in the front abd 2 in the back - The cage shoudl hang below the pneumatic boat - Cage could be chains, metal or carbon fiber, whatever protects from predators but does not create too much draft - boat should be possible to be disassembled and assembled and shipped internationally. So it should be possible to break it into pieces thata fit in 2x4 meter pallet - a solution should be conceived to have it towed by boat in the front or pushed by a motor in the back I am looking for someone that designs and then manufactures de boat.

we need drawing design box for plastic injection

I want to design and develop a pcb board looking for free lancers for the same