Build me a software using VB.NET that works with Arduino Uno and Allan Universal Coin Acceptor

Hi, I hope you are doing well. I have expertise in embedded system design and development. I have worked with Arduino and Coin Accepter Module. I have reviewed your project details and would like to ask few questions. Please send me message for further discussion. Looking Forward, Khawaja

Hi, I have previously written a VB.NET application to monitor an Arduino that was connected via USB using the SerialPort control. The Arduino had several input devices attached (buttons) as well as some LED indicators. The VB.NET code then performed specific tasks based on the inputs from the Arduino device. I can deliver a heavily commented solution within a few days. Look forward to hearing from you, Caleb.

How are you? Like you see in my profile and portfolios, I have rich experience in C/C++, C#, and Python programming as well as microcontrollers. Especially, I completed many arduino and raspberry pi projects for such features. I would like to discuss with you and get more detail requirements. Please give me your details, then I will provide best solution for you. Thanks

Hi Thanks for inviting me for this project. I holds a good experience in Arduino and .Net application development Lets discuss on pm and start the things

I am an engineer and confident of what I can do and deliver. I can work on C++, Arduino, Python, Matlab, Java among others. I am asking for a chance to work with you on your project. Thanks

yes buddy,,how r u,,thanx for inviting me,,i was busy so i m replying late,,,,Now please tell me,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

Greetings, I have good knowledge of the software development and arduino sketch writing. I have 3+ years of experience in the same. Please ping me for further discussion Thank you Best Regards Saurabh

Hi. I work as Hardware Engineer in a company that develop IOT projects. My responsibilities in the enterprise are: Design the electronic circuits (analog, digital, control and power); Develop the code for the MCU and embedded systems using software like MPLAB X IDE, Arduino IDE and Python; Test and simulate the schematic of the circuit through simulation software (Proteus and MATLAB/Simulink); Calculate the electrical parameters of the components to implement the circuits on a PCB; Design the PCB of the electronic circuits using software like Altium and Eagle; Redesign schematics and PCB layout for old prototype of circuits with the idea of update the embedded system with new technologies. I have made projects relationated with the home automation using the internet of things using Wi-Fi and Bluetooth modules (ESP8266, ESP32 and Rapsberry Pi) and TCP/IP protocol mostly, but also using UART, I2C, SPI and 1 WIRE to communicate MCU with sensor, mostly current sensors and humidity and temperature sensor (DHT22). Also, the implementation of PIC12F, PIC16F, PIC18F, PIC24F and PIC32F, to make create sub circuits to measure data from sensors, creating small devices inside if the embedded system, like the design of a digital wattmeter with I2C communication with the master (ESP12F) using the PIC16F877A, Current and Voltage transformers. All of these projects are posted on my profile. Hope that I have fulfilled your expectations and can be a good candidate to work for your project.

Hello, I have 3 years of experience in internet of things. I am able to control appliances via internet using cloud or Bluetooth. Also able to work on raspberry Pi, Arduino, esp and other hardware programming. kindly share more details to proceed further. thanks