Design a Buck Converter in Proteus Using Arduino

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in SMPS, supplies design from few watts to KW range using Buck, Boost, Buck -boost, Push Pull and H-bridge inverters I am excellent in solar, wind, Micro grid, smart grid and IEEE bus systems development in MATLAB Simulink Design, PSPICE, PSIM ,MULTISIM and LTSpice , Proteus Simulations. I did many projects for MS and PhD thesis like grid connected solar, wind, wave energy grid connected systems using MPPT, Multi-level converters, hybrid systems development and D-STATCOMs, FACTS devices for power stability, quality and control electrical vehicles, inductor motors. I worked for vehicle design simulation for different applications. I use to design Solar with MPPT using buck, buck-boost topologies, Power quality and control using Active filters, Opamp based circuit, digital circuits etc. I understand your requirement and ready to work for you. Please contact me for further discussion.

Hi, I am an electrical engineer having an experience of four years in power electronics and embedded industry. I have simulate and implement All DC-DC converters using microcontrollers in close loop. Do let me know if you have any queries/questions. Let us at least get into the interview stage and discuss things. Hoping to hear from you, Jaydip Kathiriya

FREELANCER RECOMMENDED ------------------------------------------------------ Can help... I am an Expert... Lets Start! Please start a Discussion with me and we can get started from there... Please check the past projects I have handled and check my reviews for what employers have to say about my work... Can start right now...

Hi, I am an Electronics Engineer . I have made many buck converter designs both synchronous and asynchronous. I have used PWM controller IC for switching the MOSFET at a high frequency. I have also used Arduino Nano as PWM controller and feedback through proper tuning of feedback closed loop circuit. So this is really a very easy task for me to do. I will assure you quality work and on time delivery. Looking forward to work with you..

Hello sir I am expert at the electronic circuits design and very familiar with proteus. You can take look at reviews and portfolio. As i have done previous pcb designs using proteus So please measage me for details and i am ready to start also to know more details about the converter specifcations Regards

A proposal has not yet been provided

A proposal has not yet been provided

I believe that I'm the best candidate for this project because I completely understand your requirement , and have both the concept and hardware knowledge of your project. Because I have worked on different projects related to Arduino and other Microcontrollers like PIC AVR and 8051 . And designed all of my projects on Proteus Following are some of my projects : • Designed a Wireless Bluetooth Robot controlled by smartphone by using Arduino • Designed a conveyor belt using 8051 Microcontroller • Developed a Yardmeter on Arduino Which is used to measure the length of thread in textile industry • Wireless controlling of home electronics appliances with RF module interface with Micro controller . - Controlling of quadcopter with Brain signals (EEG) using Emotiv Headset and Arduino. • FATEK and SIEMENS PLC Programming and HMI. • FPGA Altera Cyclone Programming • Digital Signal Processing on DSK C6713 • Developed a Online UPS 500W • Developed a Star Delta Starter of DC Motors Which can easily run industrial machines without any risk to their efficiency

Arduino is a awesome platform in which I am very good. and Proteus simulation was my vote subject when I was an engineering student.