light controlled motor project
$30-250 USD
Paid on delivery
Design a motor controller based on the light level on a phototransistor. When illumination is very high, the motor will be stopped while 6 volts will be applied to the motor under low light conditions. Measure (characterize) the properties of the phototransistor under both light and dark conditions in order to design the circuit and calculate component values. Be sure to justify all component values and provide calculations for critical parts of your design. A table listing all components and briefly noting how values were derived is required. An op amp is be used in the project along with a TIP-31 transistor. Good parts layout along with the use of bypass capacitors will greatly increase the likelihood that the circuit meets all specifications.
Design the audio signal generator as specified above and demonstrate that it works in LTspice
The example below is an example that was not completed but thats how the format of the project is suppose to look.
Project ID: #18344657
About the project
7 freelancers are bidding on average $227 for this job
Professional engineer with 40 years of design and development expertise...............................................................
Hello I'm Mohamed Saeed. mechanical engineer with high experience. I have checked your job description and I'm ready to help you
I am an engineer, I have successfully executed many engineering task than you can ever imagine both on freelancer and off freelancer. It will be a pleasure working with you on this one Sir. Thanks
Hello, I am interested in your project and I hope to help you realize it, I am passionate about electronics and embedded development and I hope to share with you my knowledge and experience. I can do this work in 10 d More
