Micro Drone / UAV Flight Controller -- 3
$15-25 CAD / hour
I require a experienced engineer to work on a Micro Drone | UAV Flight Controller.
To be successful at this project you will be required to assist with analysis of the drone firmware which is written in C.
You will also need to be an expert at Electrical Circuit design as well as Micro PCB design (Eagle or Altium).
Multiple layers on the PCB is a must to keep the design of the board to a very small footprint 20mm x 20mm. You must have experience with designing small PCB's.
Experience with Electronic Speed Controllers (ESC's) and Brushless motors would be a bonus.
This project will take 20 - 30 hours a week for a minimum of 3 weeks to complete
Only qualified applicants who have the time/availability will be considered.
Project ID: #10754565
About the project
Awarded to:
Dear Hiring Manager, I am glad to find you as a professional client here, I hope my assumptions are right and we'll have a wonderful experience together. Here is my introduction. I'm a professional electrical eng More
15 freelancers are bidding on average $31/hour for this job
Hello! How are you!? I have the experience you need! I have 5 years experience as an electronics design engineer. Please look at my profile. I have experience in ANSI C programming and also in schedulers. I have also e More
i have 4 years experience in embedded systems and pcb design with eagle Cadsoftware software and altium designer software . so I can do your job within a time limit with your satisfaction.
Hi , I am an embedded system design engineer with the experience of designing PCBs with tight dimension constraints. I have designed PCBs upto 16 layers with more than 1000 components. That one works in GHz frequencie More
Hi, I’m dedicated professional Web and Desktop Programmer & Developer and also Team leader of my company. I have been working with challenge and hope to improve future plan with good network every client. If any clien More
Hello, I have completed couple of the micro pcb projects for mass production. The first one was brushless farce servo controller (peak supply current 6 amperes from 7.2V supply). The PCB was dual layer (35mm x 16mm More