DIY Garage builder here. I am looking for someone that can run an some airflow analyst numbers for my rear mount turbo design. My concern is back pressure numbers VS port velocity.
Rear Turbo 78/75 mounted 5’ from engine
Headers 1-7/8 equal length 31.5” to collector
Merge collector (2)(4-1) 3” flange
3” reduced to 2.5” at each bank
Y piped using 2 45s merged into 1
2’ of 2.5” upsized to 3” at turbo
Im looking for input to see how the design can be improved.
Attached are pictures
17 freelancers are bidding on average $142 for this job
How are you? I'm Ait Oubella from Morocco. I am a mechanical engineering expert and have 7 years of experience in Solidworks, Mechanical engineering, CAD/CAM. I can make the 3d modeling and drawing. Regards.
I am having good exposure in Engine 1D simulation. I can solve this by running a small simulation kindly share the Exhaust pipe dimensions & Initial boundary condition