Code STM32 chip as led multiplexer

Hi,Hope you are doing well! I’ve read and understood your project description about"Code stm32 " Thanks for sharing your project requirement. It will be our great pleasure to work on your project. I have checked your r More

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding for More

Hey there. I'm professional electrical engineer. I'm expert in circuit design and simulations tasks. I have vast experience in MICRO CONTROLLERS. I can do your task perfectly

We are a team of Electrical and Electronics engineers and we are Excellence in the following areas: • Embedded C Programming. • VHDL/Verilog, LABView/ Multisim • Network Simulator NS2/3 • Microcontroller like Arduino, More

Hello dear project owner i am an Electronic Engineer with experience in embedded system designing and PCB designing and IOT. i can do this for you in two days.

Hi, I can help you with deveopng code to make an LED multiplexer from STM32 chip. Please refer to me profile to know more about me. Feel free to contact me for any further clarifications Thanks and regards

Hi there, We can surely code a STM32 chip to act as a led multiplexer. Please share the schematic for better insights. Kindly spare 10 minutes for the interview. We have already developed many electronic products:- G More

Hello, The 200 LEDs multiplexer code for stm32 is trivial for me. The main issue is that programming the LEDs sequence may take some time. I have seen the video, is that the sequence you need?? Thanks. Gracias

hello sir. Hope you doing well. We think We can absolutely full fill your requirements. We have a Experienced and Professional circuit designers and programmers team .where we work in the embedded systems and firmware More

Hello there, I am really interested in helping you develop the code. I have experience in providing software solutions using Unity-3D in collaboration with BMW Group, Desiginig, biulding and deploying several optimized More

I watched your video. In the description, you must write the controller type and provide the schema. I can help you with this project.I work in the environment Cube IDE

Hi, I am experienced in working with STM32 hardware and software. I can do the multiplexing work efficiently. let me know if we can work together.

I may not be the best, but i can to the task perfectly ,as seen in the video , the task isn't so hard ,and it doesn't requires to be the best to do it

Hi! I recently have done a very similar project to yours. I developed a device with STM32F303 to control 100 LEDs using multiplexers. I am using Atollic TrueStudio, STM32CubeMX, HAL libraries and more tools from ST. Ch More