Longlight Firmware

Closed Posted 5 years ago Paid on delivery
Closed Paid on delivery

Hardware description

Light source: 1 or 2 ledstrip SK6812 (similar WS2812) with individually adressable leds.

Ledstrip can be RGB, RGBW or WWA (wharm white and amber)

Length 1 m (144 leds) or custom specified

Microprocessor control board: Teensy LC or alternative

Resistive touch strip with two channels, connected to analog inputs of Teensy.

Touch strip has same length as ledstrip.

At each end of the touch-strip is a separate switch (zone of 20mm) with separate voltage output. Pressing it sends >2v signal to Teensy.

Power supply 5 volt 20A

Mechanical: Lens and led protection, profile, strip and support

Firmware description

The Teensy LC can be programmed as an Arduino compatible board, using Teensyduino installer. [login to view URL]

Libraries for driving LEDs use FastLed and FastLed RGBW

The code can be tested during Skype and Teamviewer sessions, step by step development of code is suggested. It is not necessary to build hardware.

Arduino C Programming Electrical Engineering Electronics Microcontroller

Project ID: #17186829

About the project

10 proposals Remote project Active 5 years ago

10 freelancers are bidding on average $201 for this job

aliserbetci

Hi, I have both worked with WS2812 and SK6812 led strips. I used atmega328(Uno's mcu) and Nextion's LCD. It was spesific project for trucks I would like to share its videos over the chat. Yours Truly, Ali SERBETCI

$500 USD in 10 days
(31 Reviews)
6.5
mechatronicsengr

Hi, I hope you are doing well. I have experience in LED based embedded project development. I have worked with WS2812B based LED strips. I have understood your requirements and would like to discuss the project f More

$250 USD in 5 days
(95 Reviews)
6.9
ircrashed

Hello I have got your job posting “Longlight Firmware” and I am very much interested to work in your project. I am a circuit designer and have more than 5 years experience of working with the Analog/Digital Elec More

$200 USD in 10 days
(55 Reviews)
5.8
AhmedSobhiSaleh

Hi, I am a professional electrical engineer. I am an expert in designing and simulating systems and writing arduino codes I also have the hardware to test and confirm working code. You can see some of my work in my por More

$166 USD in 3 days
(25 Reviews)
5.1
Omaresl

Hello I can help you with your project. I have more than 4 years of experience programming embedded systems including arduino. I have some background developing code for Lighting systems. (DMX protocol for lighti More

$160 USD in 10 days
(14 Reviews)
4.2
MRienhart

I am an experienced Arduino programmer and I have worked with Ws2812 addressable led strips before. Thanks for the consideration!

$155 USD in 3 days
(2 Reviews)
3.6
yousafrehman

As long as Arduino is concerned, I can make it on it easily. I can also work on this alternative microprcessor.

$111 USD in 5 days
(0 Reviews)
0.0