I am looking for a PIC guru that can create the HEX code for the pic18f4455 and also the VB/C#.net code to run the board.
I will need to create a smaller version of the final design (2 fans/ in order to test it out on my end without the added cost of all 10 fan controls. The pic18f4455 should be controlled via USB Protocol.
The final PCB should have the following:
- 10 CH PWM outputs
- 10 CH Tacho inputs
- 10 CH Temp
So to break down what I am looking for:
1) HEX code for the PIC.
2) VB or C# code to run/read the PIC.
3) PCB board layout (SMD components are fine to use) as small size as you can make it with also the smaller version PCB for testing. Please have a BOM of parts needed via Digikey.com.
24 freelancers are bidding on average $2763 for this job
Hi, I hope you are doing well. I read your project details . I have understood your requirements and I would like to discuss it in more details. Looking Forward, Khawaja
Hi, I can help you. but I suggest to split project - normally good programmer is not good in PCB design. So Have you schematic or you need also schematic?
Hello I am a novice freelancer. Ready to discuss your project at a lower cost with the recall. I am a .Net developer. I was developed as an application on the same sites with #