Creating a SierraChart system

PLEASE VISIT [login to view URL] AND CHECK THE DOCUMENTATION BEFORE BIDDING I would liked to you to turn a current trading script into a system that sends orders to the simulation (backtesting) / broker so i could backtest and trade it using Sierracharts. A: [login to view URL], you should register for a free trail. they have lots of demo inside + well documented + good forum B: you should have a bid/ask (tick data) data provider (you can trail with [login to view URL]) C: Sierracharts is a software which is similar to Metatrader but it's not using MQL D: I have more projects in this great environment. pls consider when bidding future projects as well. The final script should be able to send orders to a broker (IB preferred) and complete a backtetsing upon next requirements: 1. buy/sell X # (parameter) mkt/limit orders (mkt/limit should be a parameter + we send a stop order only if we are filled) 1.1. based on the scripts logic it's going long (short) only if it breaks the high (low) of the prior bar. i would like to add a filter: don't enter if the break of previous bar's high/low is on volume which is less than "X" (20 for dax and 1000 for es for example) 1.2. buy/sell below (if enabled) the entry level (which is the mkt order) so if the first trade was mkt at the trigger price i would like to buy more at the entry -2 points and than buy more at the entry price - 4 points as long as it's not <= the stop price (if the first trade was executed at the trigger price i would like to buy more at the entry - 2 points and than buy more at the entry price - 4 points as long as it's not <= the stop price). 2. sell % of position on multiply targets 2.1 sell X% of position @ target #1 at execution + X ticks (defined in the setup screen) 2.2 sell Z% of position @ target #2 at execution + 2X ticks (defined in the setup screen) 2.3 sell y% of position @ target #3 (if enabled, else only targets 1+2) is a trailing for the low of the prior bar (target 2 and target 3 should be set in the "settings tab" and their values should be in % of the stop and on negative. so target 2 will be 25% off the first entry ((entry minus stop)*0.25) and target 3 will be ((entry minus stop)*0.4)) 2.4 update targets upon avg execution price 2.5 when target 1 is filled (and we where filled) than raise stop to a. entry price or b. POC (point of control) of bar - (minus) 1 tick 3. send stop market order for all position as defined in the script as a bracket 3.1 if buying below entry price than update the amount of contracts in the stop 3.2 adding an option to locate the stop below/above the POC (point of control) of the bar based on if i am on long/short 3.3 adding an option for stop and reverse. if i was stopped than sell as twice as the amount i had and use same 1/2/3 targets but to the other side. stop will be original entry 4. detailed logging to txt file (the file will have a header of all the settings used for that day and than every trade will have the following fildes: asset,date,time,trade#,sub order #,entry,avg entry,exit, exit time, time in market, exit based on stop/t.p., POC price). also when sending an order to broker a comment in the order execution should be sent as well for later use. 5. all orders are OCO (order cancel order: if target is executed than cancel the stop and vice versa) 6. adding start/end time for trading (i don't want to trade overnight etc.) PLEASE VISIT [login to view URL] AND CHECK THE DOCUMENTATION BEFORE BIDDING