Arduino Programming code and layout
$30-250 USD
Paid on delivery
I need a programmer to make my project work using arduino. attached is the circuits that i had and the operation steps will be further described below.
Operation Steps is described as below :
1) Switch on the main power switch and the ultrasonic sensor will perform an initial distance measurement on the Y-axis (e.g. initial distance of 30cm height is taken as reference point). It will feedback to the micro controller. (The initial distance always varies for each usage so it must perform the initial distance measurement prior to each usage.)
2) The micro controller will activate the stepper motor to move the prototype only 4cm on the Y-axis (e.g. it will stop at the height of 26cm and go back to the reference distance initially measured at 30cm.)
3) Repeat moving from reference point to height of 26cm for 30second.
4) After 30 second at the reference point, Pause for pulse taking, If no pulse detected, continue moving from reference point to height of 26cm for 10 second while LED is light up.
5) 10 second later, pause again at reference point, LED switch off.
6) Immediately pause for pulse taking, if no pulse detected, repeat step 4 and 5.
7) If pulse is detected, all operation stop and pulse sensor will monitor the pulse.
8) Lastly, if no pulse is detected again, repeat step 4 to 7.
9) A emergency stop button to stop all operation.
(In between of each step, there will be a voice instruction and display output from the wave shield and LCD Screen)
Project ID: #7062187
About the project
Awarded to:
It is easy job for me, so my bid is low and we can work later together on different arduino projects.
15 freelancers are bidding on average $261 for this job
I am Embedded System Design and Development Engineer. I have expertise in Microcontroller Programming and development on AVR (ATmega and ATtiny), Arduino and ARM (Cortex M0 and Cortex M4) in C/C++/Assembly Language. I More
Hi There, We will built the circuit, program the arduino and show you the working of whole project on skype. Once you are OK with performance we will deliver the design. Following shall be the deliverable. furtherm More
i am an electronics engineer with 4 years of experience. i have experience with arduino and can do this job. please contact me to discuss details
ACTUAL BIDDER! NOT A SUBCONTRACTOR!!! Hello, i have a PhD in Mechatronics and ample experience with Arduino boards, as well as microcontrollers. I have most of the hardware needed to get this started and have worke More
Interesting Project, Dear Sir, I have vast experience in arduino programming and development sensor based electronic systems. I have worked with UNO,MEGA, MINI and also have developed arduino compatible controller b More
Hello! I have a wide experience in arduino programming. I'm already worked with ultarsonic sensor, motors, and TFT. Feel free for any questions. Thanks!
I have corresponding degree from university and work experience with similar projects. The work will be done with required quality level.