Design H bridge Schematics and PCB
$30-250 USD
Paid on delivery
Require Electronic Engineer for a small job.
Things need to make
1. Schematics design
2. PCB design only
Of H-bridge having these features
Output Max Voltage : 220 VDC
Output Max Current : 20A
Input Signal Can Have PWM (5 VDC)
Frequency Range : 4Hz to 50Hz
Duty Cycle Range : 0.1% to 100%
Must use Optocoupler between signal and H-Bridge.
You will be paid, once I will test everything on my end.
Project ID: #9900884
About the project
21 freelancers are bidding on average $142 for this job
Hi, I am a post graduate power electronics engineer and having very good industrial experience of 8+ years in R&D and project development. I am excellent high frequency transformers design,circuits design, Regulated p More
Hello, I have a great experience in electronics and schematics design and PCB. please have a look at my profile. One of the projects that I have done and very similar to your project is a Full bridge switched mode po More
hi, I'm Electrical Engineer with specialized in Electronics. I have 2 years of experience working on PCB designing and PWM circuitry. i'm sure i can do this job for you with 100% accuracy. Please contact me for more de More
hi, I have experience in power electronics. I can do this task easily. To get 0 to 100 % PWM isolated power supply modules are required (as boot-strapping will not work in this case). I will use IGBT for better More
Hello! I would like to help you with your project. Please tell me what are the switching element for you H-bridge: IGBT, MOSFETS or anything else? What are the dimensions of the board? maybe you have schematic for th More
I am a mechtronics engineer. i have the design for CMOS transistors being used for an H bridge along with optocouplers. Your requirements shall all be fulfilled. we used to this in NERC ( National Engineering Robotic More
Hey I am an Engineer and I have done a lot of work of circuit designing (hardware as well as software), and even I have used H Bridge in one of my project so I have understood your requirements.
I am doing MS electrical engineering and worked on H-bridge a lot, I suggest two solution for u 1- Using power electronics devices ( need more care for handling) 2- Using switching transistor with 4 relay ( raged , More
i can do this job because i have already design it with 30 amps . i have designed it using booststrap mosfet driver .