Class A common emitter BJT amplifier

In Progress Posted Dec 12, 2009 Paid on delivery
In Progress Paid on delivery

Class A amplifier Project

As part of an electronic system a common emitter class A amplifier is required to be designed and simulated using Pspice. This amplifier uses the BJT Q2N2222 that can be biased using one power supply of 18 volts DC. This amplifier feeds another stage with input impedance of 17k ohms. The amplifier should amplify a signal with frequencies between 210Hz and 50kHz. At the medium frequencies range the output signal is required to be 95 times larger than the input signal which is 7mVrms AC. The collector current at operating point ICq is of 10 mA. Nominal preferred values for components should be used and all calculations for component values should be shown.

Known values are here as shown:

Vin = 7mV RMS

Vcc = 18v

Lower cut-off frequency = 210Hz

Higher cut-off frequency = 50kHz

Output impedence (ROUT) = 17k ohms

Vout / Vin = 95

Collector current Icq = 10mA

The screenshot attached is roughly what the circuit should look like.

A screenshot of the schematic and the schematic itself are attached to the file.

What I need is somebody who can calculate the correct values of the components shown on the schematic send send me them so I can modify the circuit to give the desired output. Any questions please contact me, thanks.

Electrical Engineering Electronics

Project ID: #569903

About the project

14 proposals Remote project Active Dec 14, 2009

Awarded to:

vishaliitkgp

hi, your circuit is very easy. i can give you the solutions within 1 day only with the complete simulation results. thanks

$30 USD in 1 day
(1 Review)
0.0

14 freelancers are bidding on average $61 for this job

mayyurp

I am Electronics engineer and can provide you values you required.

$30 USD in 3 days
(0 Reviews)
0.0
sumairahmad

I have work experience with orcid pspice. I can help you.

$150 USD in 5 days
(0 Reviews)
0.0
VKElectronics

piece of cake I do engineering and have a hot-shot russian electronics engineer I work with

$30 USD in 2 days
(0 Reviews)
0.0
chetanfadnis

$200, completion within 1 days.

$200 USD in 1 day
(0 Reviews)
0.0
amitsaturn

hi boss, plz refer my PM..thank u..

$40 USD in 1 day
(1 Review)
0.0
makinmakin

See details in MB.

$35 USD in 2 days
(2 Reviews)
4.5
rmilan

Please check Your pm, thanks.

$30 USD in 1 day
(0 Reviews)
0.0
Ellite123

Hi Please check PM. Regards

$80 USD in 1 day
(1 Review)
0.0
maxonlyforyou

RB1=20k RB2=1k RC=1k5 RE=10 Ohm CE=150n CIN=COUT=4700n I don't need your money. Price calculation -- your story about why you made this project and story about electronics in your countr More

$30 USD in 1 day
(0 Reviews)
0.0
zamroo

Hi, I am ready to work on it.

$60 USD in 5 days
(0 Reviews)
0.0
idreesshahzad

Hi, I can provide the solution for this project

$60 USD in 1 day
(0 Reviews)
0.0