Xbreak SamD21 Controller

This project was awarded to RegulViktor for $83 USD.

Get free quotes for a project like this
Project Budget
$30 - $250 USD
Total Bids
Project Description

Using existing design as reference, create Xbreak Zero

Consists of:

Sam D21 Processor

SD Card

LCD Interface

Lots of USB 3.1 (xbreak specific)

Type 1 - Consists of 2 X PIO with SPI and I2C

Type 2 - Sam as above but second PIO is selection for Analog IO

6 Pin Pci Express Power

Note I've already done this, but with PCI Express connectors, so larges amounts of the schematic can be used. USB 3.1 Foot Print, and pinout defined.

Note: In addition to main board, three simple add on boards are needed:

1. Stepper Driver - Using USB 3.1 Connecto, connect to typical reprap stepper driver

USB 3.1 Connector

DIP Socket for Stepper Driver

Stepper Driver 4 pin connector

2. Light Thermal Control Board - Using USB3.1 Only and a FET, plus a external thermistor, drive a "hotend" heater

3. Heavy Thermal Control board - rev of above - but adds a 6 Pin Pci Express Connectior

Awarded to:
Skills Required

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online