i want to use Labview to control the motor of speed. 3 stepper motor. 2 of the motors will be rotating from 1 Rpm to 60Rpm and one of the motor rotates less than or equal to 8mm/hr. further details we will chat
I need a little update in my Test Program (Labwindows). All code and GUI and all is done, just need program be capable to send email automatically to specified people when yields goes down <97%.
ADAPTIVE MODULATION AND CODING REQUIREMENTS: *Bandwidth =20 MHz; *Number of FFT NFFT=64; *Number of Data subcarrier Nd = 48; *Number of pilot Np =4; *Guard Interval = ¼ of symbol period Ts; *OFDM transmission: 52 (i.e Nd+Np) *Pilot data interval = 13 sub-carriers, starting from the 6th; *Indices of the pilot sub-carier = 6th, 19th, 32nd and 45th sub-carrier; * All mandatory and o...
LabVIEW, Electrical Engineering, Electronics, Microcontroller, Embedded Software, Software Development, Software Architecture
Interfacing the variables of MYRIO to main VI so that these variables can be controlled from Main VI
1 - Objective Design and implementation of a basic system of acquisition of data in Arduino Uno. 2 - Work Requirements 1. Analyze the amount of available memory on Arduino Uno for data storage. (estimate number of samples). 2. Analyze the type of ADC in Arduino. 3. Analyze maximum sampling frequency (use appropriate range). 4. Use of the trigger button. 3 - Test Requirements 1. Use of a si...
I need some help with LabVIEW using IMAQ module. In this code, one need to read raw/column of the Image and do some Image/array element processing. More detail can be provided upon contacting me.
r u in and around Bangalore would like to be done from our location due to few contract constrains and issues in providing remote access . we can talk over the phone on the feasibility regards, victor [Removed by admin]
The objective of this project is to construct a VI which will display X and Y cursors on a waveform graph and move the X and Y cursors when the mouse is over the plot area of the waveform graph...find more information in the instruction doc
Arduino based PLC programmer. Looking for an arduino based PLC programmer . SW design is ready to be implemented. Old code available in VB. PLC will monitor and control various live sensors. ( 50 sensors) NDA will be required before start. Estimated work in total number of hours: 70.
I am making a flight control system for a drone, using Matlab(Simulink) and the hardware I am testing it on is a Pixhawk. It's an inertial navigation system, so I am not allowed to use GPS or Opticflow sensors! The Pixhawk has a built in Gyroscopes and Accelerometers to get IMU readings. Using IMU the simulink model will double integrate and find distance and its position relative to home. It...